YS200-63A-1 ; YS double suction centrifugal oil pump

YS, YS-1 YS double suction centrifugal oil pump YS-1 pump is a two-end extension shaft, derived from YS. YS and YS-1 pumps are suitable for petrochemical plants to transport non-corrosive oils and petroleum products that do not contain solid particles and have a viscosity of less than 120 centistokes. The medium temperature of the YS pump is -20℃～80℃. The pump inlet pressure is not higher than 0.6MPa.

YS oil pump parameter range:
Flow rate Q 72288m 3 /s
Lift H 24104m

YS oil pump model description:
YS200-63A - 1
YS-Single-stage, double-suction horizontal split centrifugal oil pump
200 - pump suction diameter is 200mm
63 - The pump design point head is 63mm
A- Impeller outer diameter changes
1-Extension shafts at both ends of the pump

YS oil pump structure:
The suction and discharge ports of YS and YS-1 pumps are both below the centerline of the pump shaft and perpendicular to the pump axis. The separation surface of the pump body and pump cover is on the centerline of the shaft for easy maintenance. The shaft seal is a packing seal, and the rotor is supported by rolling bearings, which are grease lubricated.

YS type oil pump rotation direction:
Viewed from the motor end, the pump rotates counterclockwise. The direction of rotation of the YS-1 pump is the same as that of the YS pump.

YS type oil pump main parts material:
The pump's flow-through parts are made of cast iron, cast steel, and cast stainless steel.